Grass Valley iControl V.4.43 - Manual (Page 486)

iControl and SNMP
Creating a Trap Map
476
To create a trap map
1. Open the Create Trap Map window by doing ONE of the following:
• In SNMP Driver Creator, on the Alarms tab, click New trap map.
Figure 8-62
OR,
• In either the Add Alarm window or the Edit Alarm window, click New trap map.
The Create Trap Map window appears.
Figure 8-63
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 737 ).
• you have loaded a MIB module into SNMP Driver Creator (see page 462 ).