Grass Valley iControl V.4.43 - Manual (Page 162)

Logs
Filtering a Log Search Using Multiple Criteria
152
To filter a log search using multiple criteria
1. If you are performing this procedure to create a channel performance report template,
perform the following sub-steps:
a) Select the Source ID string associated with your report template’s virtual alarm in the
Source ID list
Figure 4-62
Note: The Ellipsis buttons ( ) in the Device properties, Alarm properties, and
Alarm State areas signify a logical OR joining several criteria in a single filtered
search. By contrast, the Ellipsis buttons in the Event time area allow you to specify an
event time on a calendar (see
"Using the Calendar" , on page 160).
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened either Event Log Viewer or Incident Log Viewer, as required
(see "Opening Event Log Viewer" , on page 721 and "Opening Incident Log Viewer" , on
page 724).
• If you are performing this procedure in the context of creating a channel performance
report template, make sure:
• You have created a virtual alarm that filters out non-channel alarms.
• You know the virtual alarm’s Source ID string.
See "Creating a Virtual Alarm to Filter Out Non-Channel Alarms (iC Reports)" , on
page 405.