B&B Electronics WOP-2121V-N4AE - Manual - Manual (Page 89)

3
PM Designer Operation Manual
3-28
CHAPTER 3 CREATING PANEL APPLICATIONS
3.4.5. Sub-link Settings
This section describes how to define the sub-links for the direct links using the Sub-link page of the Link Properties dialog
box. The following is an example of the Sub-link page.
The following table describes each property in the Sub-link page of the Link Properties dialog box for a direct link.
Property Description
Number of sub-links Specifies how many devices the link will connects as sub-links.
Language Specifies the current language for the Name field.
Name The name of the selected sub-link for the language specified in the Language field.
Node Address The address of the selected sub-link. The address must be a unique number within all the
sub-links.
Initial State The initial communication state for the selected sub-link. If the state is On, the panel will
communicate with the sub-link after running the application. If the state is Off, the panel will
not communicate with the sub-link until the communication state is turn On in a sub-link
table.
Show error message If this option is checked, the communication error message will be shown when the selected
sub-link encounters communication errors. If this option is unchecked, no error message will
be shown for any communication errors.