B&B Electronics I-7060 - Manual User Manual
I-7000 dio manual
1
I-7000 DIO Manual
Rev:B1.2
Warranty
All products manufactured by ICP DAS are warranted
against defective materials for a period of one year from the date
of delivery to the original purchaser.
Warning
ICP DAS assume no liability for damages consequent to
the use of this product. ICP DAS reserves the right to change this
manual at any time without notice. The information furnished by
ICP DAS is believed to be accurate and reliable. However, no
responsibility is assumed by ICP DAS for its use, nor for any in-
fringements of patents or other rights of third parties resulting from
its use.
Copyright
Copyright 1999 by ICP DAS. All rights are reserved.
Trademark
The names used for identification only maybe registered
trademarks of their respective companies.
I-7000 DIO Manual
Date:2000-02
Document Outline
- Table of Contents
- 1. Introduction
- 1.1 More Information
- 1.2 Pin Assignment
- 1.3 Specifications
- 1.4 Block Diagram
- 1.5 Wire Connection
- 1.6 Quick Start
- 1.7 Default Setting
- 1.8 Jumper Setting
- 1.9 Configuration Tables
- 2. Command
- 2.1 %AANNTTCCFF
- 2.2 #**
- 2.3 #AABBDD
- 2.4 #AAN
- 2.5 $AA2
- 2.6 $AA4
- 2.7 $AA5
- 2.8 $AA6
- 2.9 $AAF
- 2.10 $AAM
- 2.11 $AAC
- 2.12 $AACN
- 2.13 $AALS
- 2.14 @AA
- 2.15 @AA(Data)
- 2.16 ~AAO(Data)
- 2.17 ~**
- 2.18 ~AA0
- 2.19 ~AA1
- 2.20 ~AA2
- 2.21 ~AA3EVV
- 2.22 ~AA4V
- 2.23 ~AA5V
- 3. Application Note
- 3.1 INIT* pin Operation
- 3.2 Module Status
- 3.3 Dual Watchdog Operation
- 3.4 Reset Status
- 3.5 Digital Output
- 3.6 Latch Digital Input
- 4 DN Module
- 4.1 DN-SSR4
- 4.2 DN-PR4
- 4.3 RM-104, RM-108, RM-116
- 4.4 RM-204, RM-208, RM-216
- 4.5 Application