Getting started, Pm designer operation manual – B&B Electronics WOP-2121V-N4AE - Manual User Manual
Page 3

4
1
PM Designer Operation Manual
1-1
CHAPTER 1 INTRODUCTION
1.1. Getting Started
Welcome to PM Designer
The configuration software for PanelMaster and PanelExpress HMI products
Thank you for purchasing PM Designer. This manual describes PM Designer operation procedures and details about each
feature.
Notes
1) All programs and documentation included with PM Designer ("this product") are the copyright of Cermate Technologies
Incorporation, and are licensed to the user under the Software License Agreement. Any violation of the conditions
described in the Software License Agreement is prohibited under Taiwanese and international laws.
2) Cermate Technologies Incorporation makes every attempt to provide the user with functionality and usability of the
Product and accuracy of its documentation. However, if you should find any errors or omissions in this manual, please
contact Cermate Technologies Incorporation.
3) Regardless of the above provisions, Cermate Technologies Incorporation shall not be held responsible for any
damages or third party claims resulting from the use of this product.
4) Difference may occur between the descriptions found in this manual and the actual functioning of this product. For the
latest information, please refer to the provided data files (i.e. readme.txt files, etc) or other Cermate Technologies
Incorporation documentation.
5) Information recorded in or displayed by this product may include content related to intangible assets or intellectual
properties owned by Cermate Technologies Incorporation or by a third-party. However, this does not imply that
Cermate Technologies Incorporation grants the user or other third-parties any license or permits to use such assets or
properties.
Precautions
1) Do not use the touch panel switch as an emergency stop switch. For safety reasons, it is required that all industrial
machinery and systems must be equipped with a mechanical, manually-operated emergency stop switch.
2) Do not use the touch panel switch that could result in human injury or equipment damage. Failure with the touch panel,
the processing unit, and the cables that makes the output stuck at ON or OFF could result in a serious accident.
1.1.1. Documentation Conventions
Product-related Abbreviations and Terminology
This manual uses the following terminology.
Terminology
Description
Controller
Indicates controller, such as programmable logic controllers (PLCs), motion controllers, thermal
controllers, inverters, and so on.
Application
The screen application created with the PM Designer on the PC.
Target Panel
The HMI (Human-Machine Interface) unit or the computer that runs PanelExpress where the screen
application is downloaded to and displayed.
This manual uses the following abbreviations.
Abbreviations
Corresponding Target Panel
PM
All PanelMaster Series
PE
PanelExpress
LSK
PL037-LSK, PV037-LSK, PV037V-LSK,
PL057-LSK, PV057-LSK, PV057V-LSK
TSK
PL057-TSK, PV057-TSK, PV057V-TSK