B&B Electronics WOP-2121V-N4AE - Manual - Manual (Page 148)

4
PM Designer Operation Manual
4-26
CHAPTER 4 DESIGNING SCREENS
The following table describes each property in the Scale dialog box.
Property Description
Direction and Position Select the direction and the position for the scale according to the following table.
Direction Position Example
Top Horizontal
Bottom
Left Vertical
Right
Color The color of the scale. To specify the color, click the corresponding Color icon and
select a color from the Color palette.
Number of Major Ticks The number of major ticks. The minimum you can specify is two.
Number of Sub Divisions The number of divisions between two adjacent major ticks. The minimum you can
specify is one.
Minor Tick Length The length of minor ticks.
Axis Check this item if you want the scale to have an axis.
Marks Check this option if you want the scale to have marks.
Font The font of the marks.
Minimum The minimum of the marks. It is a 32-bit integer.
Maximum The maximum of the marks. It is a 32-bit integer.
Total Digits The total digits to be displayed for the marks.
Fractional Digits The number of fractional digits for the marks. For example, when the Maximum is
5000, the Total Digits is 4, and the Fractional Digits is 2, the mark for the Maximum
will be 50.00.
Marks
Reverse Order Check this option if you want the marks of the scale to show in reverse order. In
normal order, the maximal mark is at the right end or top end of the scale. In reverse
order, the maximal mark is at the left end or bottom end of the scale.