B&B Electronics WOP-2121V-N4AE - Manual - Manual (Page 111)

3
PM Designer Operation Manual
3-50
CHAPTER 3 CREATING PANEL APPLICATIONS
3.8. Setting up Passwords
This section describes how to set up the passwords for the panel application using the Passwords dialog box. The
following is an example of the Passwords dialog box.
The following table describes each property in the Passwords dialog box.
Property Description
Password The Password column contains 8 fields. You can specify the password for a user level in
the corresponding field. A password is a positive integer up to 8 digits. A password must
be unique within the application.
Comment The Comment column contains 8 editable fields. You can type the comment for a
password or user level in the corresponding field.
9 Check this item if you want the developer password to be the password with the highest
privilege.
Automatic login for
operations requiring a
higher user level The password keypad will display to get a password with a higher user level when the
operator touches an object that requires a higher user level than the current one to
perform the programmed operation.
Login Trigger Bit When the specified trigger bit changes from Off to On, the password keypad will display
to get a password. The operator can enter a valid password or cancel the password
keypad.
Logout Trigger Bit When the specified trigger bit changes from Off to On, the current user level is reset to 0.
Login Timeout The password keypad will close automatically when it gets no input from the operator for
the specified time.