B&B Electronics WOP-2121V-N4AE - Manual - Manual (Page 76)

4 3
PM Designer Operation Manual
3-15
CHAPTER 3 CREATING PANEL APPLICATIONS
Property Description
Advanced The following table describes each property in the Advanced group. Some of the properties are
available when need.
Property Description
Enabled by
Bit Check this option so the operation of the object will be enabled and disabled by
the specified bit.
Bit Specifies the bit that enables and disables the touch operation.
Click to enter a bit address. Click to select a bit tag.
Enabling
State Specifies the state (On or Off) that enables the touch operation.
Enabled by
User Level Check this item so the touch operation of the object will be enabled and
disabled by the current user level.
Lowest
Enabling
User Level Specifies the lowest user level that is required to enable the touch operation.
Operator
Confirmation
Check this option if you want the operator to confirm the operation. The
Confirmation box will be displayed when the object performs the operation. If
the operator selects “Yes” in the Confirmation box, the operation will be done. If
the operator selects “No” or the operator does not respond within the specified
time period (Maximum Waiting Time), the operation will be cancelled.
Maximum
Waiting Time Specifies the maximum time that the object will wait for the operator’s
confirmation. The operation will be cancelled if the operator does not respond
within this time.
Notification Check this option so the object will notify the specified bit after it finishes the
operation.
Bit Specifies the bit that receives the notification.
State Specifies the state (On or Off) that is used for the notification.