Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 980)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
964 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Command variables
The following command variables are generated in the method run by the
command MEAS Opt and can be used in formulas under the designation
'Command name.Variable designation':
Identification Description
.BP{#}.[MEA] Measured value for the break-point (1…9) in the unit
of the measured value
.BP{#}.CNT Intensity for the break-point x (1…9) in counts
.BP{#}.TEM Temperature for the break-point # (1…9) in °C
.BP{#}.TIM Time for the break-point # (1…9) in s
.BP{#}.TRN Transmission for the break-point x (1…9) in %
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.FP{#}.[MEA] Measured value for the fix endpoint # (1…9) in the unit
of the measured value
.FP{#}.CNT Intensity for the fix endpoint x (1…9) in counts
.FP{#}.TEM Temperature for the fix endpoint # (1…9) in °C
.FP{#}.TIM Time for fix endpoint # (1…9) in s
.FP{#}.TRN Transmission for the fix endpoint x (1…9) in %
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.CNT Transmission of the last measuring point of the meas-
uring point list in %
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list