Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1316)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1300 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Range -2.147E+9 ... 2.147E+9 mV
Default value -30 mV
Upper limit
Upper intervention limit for E(0).
Range -2.147E+9 ... 2.147E+9 mV
Default value 30 mV
Warning limits for cell constant (only for conductivity sensors)
on | off (Default value: off)
If this option is switched on then the values for the cell constant will be
shown in orange if the limits are exceeded.
Lower limit
Lower warning limit for the cell constant.
Range 0.001 ... 500 /cm
Default value 2.0 /cm
Upper limit
Upper warning limit for the cell constant.
Range 0.001 ... 500 /cm
Default value 400 /cm
Intervention limits for cell constant (only for conductivity sen-
sors)
on | off (Default value: off)
If this option is switched on then the values for the cell constant will be
shown in red if the limits are exceeded.
Lower limit
Lower intervention limit for the cell constant.
Range 0.001 ... 500 /cm
Default value 0.001 /cm
Upper limit
Upper intervention limit for the cell constant.
Range 0.001 ... 500 /cm
Default value 500 /cm