Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1298)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1282 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
[OK]
The sensor table is produced in the required format as a PDF file and can be
opened directly with Acrobat Reader; it can then be printed out and/or
saved.
6.7.3 Sensor properties
6.7.3.1 Edit sensor properties
Dialog window: Configuration ▶ Sensors ▶ Edit ▶ Sensor
With the menu item Edit ▶ Properties… in the subwindow Sensors, the
properties window for the sensor selected in the sensor table opens in which
the parameters of the sensor can be edited. It consists of the following tabs:
￭ Sensor
General information about the sensor, such as sensor name, sensor type,
set to work, etc.
￭ Calibration data
Information about calibration of the sensor.
￭ Limits
Definition of limits monitoring for slope and electrode zero point.
￭ History
Shows the last 10 calibration values.
6.7.3.2 Properties - Sensor
Tab: Configuration ▶ Sensors ▶ Edit ▶ Sensor ▶ Sensor
Sensor name
Name of the sensor.
Input 24 characters
Note
The sensor name for the 5 non-deletable default sensors pH electrode,
Metal electrode, ISE electrode, Temperature sensor and Conduc-
tivity sensor cannot be changed.
Sensor type
Shows the type of sensor. Intelligent sensors are marked in addition with
IS.
Ion
Shows the ion to be measured and its valency. This parameter only appears
for ISE electrodes.