Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 513)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 497
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
Temperature
Temperature
Manually entered titration temperature. If a temperature sensor is connected
and the Temperature measurement is set on the General/Hardware
tab under Sensor to automatic or continuous, then the temperature will
be measured continuously. This value is used for temperature correction in
pH measurements.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value 25.0 °C
5.6.3.2.4.5 DET Ipol - Stop conditions
Tab: Method ▶ DET Ipol ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
The conditions for stopping the titration are defined on this tab. If more than
one stop condition is in effect at the same time, then the criterion which is
fulfilled first will stop the titration.
Stop volume
Stops when the given volume has been added after the start of the titration
(including start conditions). The stop volume should be adapted to suit the
sample weight or the titration vessel size.