Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 356)

4.7 Subwindow Results ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
340 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
4.7 Subwindow Results
4.7.1 Results - General
Subwindow: Database ▶ Results
In the subwindow Results in the program part Database the results cal-
culated in the calculation commands and the variables used for are shown.
It shows the results overview, the raw data of the commands with evalua-
tions as well as the results calculated in the calculation commands, statistical
evaluations, formulas and all variables used for for the determination selec-
ted in the determination overview.
When navigating in the determination overview this data will be updated
automatically (with a certain delay).
The subwindow Results can be switched on and made visible in the defi-
nition of the layout in the program part Database. It can be enlarged and
reduced as required; it can also be maximized.
Tabs
The results of the determination are shown on the following tabs:
￭ Results overview
Shows the results overview for all calculation commands.
￭ Raw data
Display of evaluation raw data for commands with evaluations.
￭ "Command name"
Show the results for a single calculation command. A tab with the cor-
responding command name is provided for each calculation command.
4.7.2 Results - Results overview
Tab: Database ▶ Result ▶ Results overview
On the tab Results overview the results for all calculation commands and
(if existent and desired) the corresponding statistical evaluations are dis-
played. The display of the statistical evaluations can be selected in the dialog
window Properties result window
Command "Command name"
For each CALC command a results overview is shown according to the fol-
lowing pattern:
"Command name"
Name of the CALC command.