Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1493)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1477
Note
We recommend masking the irrelevant output lines with an asterisk * so
as not to modify these line conditions.
Note
For Titrinos with 3 output lines, only 3 characters can be entered. If signal
pattern is selected, also only the first 3 characters will be used.
[Set]
Set the bit pattern defined under Outputs.
8.4.4 Sample changer functions
8.4.4.1 Sample changer - Overview
Program part: Manual Control
If in the subwindow for the device selection, a tower of a sample changer
is selected, then the functions and parameters belonging to this sample
changer are displayed in the subwindow Functions/Parameters.
Sample changer functions
The sample changer functions are displayed on the following tabs:
￭ General
￭ Move
￭ Assign position
￭ Pump
￭ Heater/Gas
Devices
The sample changer functions can be carried out with the following devices:
730, 774, 778, 789, 814, 815, 855, 864, 874
8.4.4.2 Sample changer - General
Program part: Manual Control
Here information on the rack attached is displayed. In addition, shift and lift
rate for manual sample changer control can be set.
Rack name
Shows the name of the rack attached. If no rack is attached, -------- is dis-
played.