Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 939)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 923
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can be
taken over and saved from existing measuring commands (i.e. MEAS) which
can also be displayed in curves under the designation Extern 1…3 and used
in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.10.2, page 859).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.10.2, page 859).
[Delete]
Deletes the external measured value selected in the table.
5.6.4.6.6 MEAS T - Fix endpoint evaluation
Dialog window: Method ▶ MEAS pH ▶ Properties... ▶ Additional evaluations ▶ Fix
endpoint evaluation #
Quantity
Selection of the fixed measured quantity to which the associated values for
the other quantities are to be interpolated from the list of measured points.
Selection Measured value | Time
Default value Measured value
Fix value
Value of the fix endpoint.
Measured value
Range
-20.0 ... 150.0 °C
Time
Range
0.0 ... 999999.9 s