Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 968)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
952 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Identification Description
.FP{x}.TIM Time in s until the fix endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point of the measuring
point list is reached
.MA.MEA Maximum measured value (U
ind
) in mV
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.SLO Slope of the sensor used in the command
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
.TC.CO Coefficient c0 of the Chebyshev polynomial of the sol-
ution used
.TC.C1 Coefficient c1 of the Chebyshev polynomial of the sol-
ution used
.TC.C2 Coefficient c2 of the Chebyshev polynomial of the sol-
ution used