Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 867)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 851
Track call on limit exceeding
In this table, which cannot be edited directly, a maximum of 20 entries can
be defined as to which track is to be started automatically when a particular
limit value is exceeded.
[New]
Opens the dialog window Track call # in which the parameters for the
track call can be entered (see Chapter 5.6.3.8.4, page 802).
[Properties]
Opens the dialog window Track call # in which the parameters for the
track call can be edited (see Chapter 5.6.3.8.4, page 802).
[Delete]
Deletes the track call selected in the table.
5.6.3.8.7.8 STAT U - Evaluations
Tab: Method ▶ STAT U ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Input 25 characters
The following methods for the evaluation of titration curves can be activated
and defined on this tab:
Rate evaluation
Rate evaluation
on | off (Default value: off)
If this check box is activated, than a maximum of 9 time slots can be defined
in which the mean dosing rate can be determined by linear regression. The
defined time slots are shown in the window table and can be edited with
the following buttons:
[New]
Opens the dialog window Evaluation window # in which the parameters
for a new time slot can be entered (see Chapter 5.6.3.8.3, page 802).
[Properties]
Opens the dialog window Evaluation window # in which the parameters
for the new time slot can be edited (see Chapter 5.6.3.8.3, page 802).
[Delete]
Deletes the time slot selected in the table.