Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1382)

7.8 730 Sample Changer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1366 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Note
Connecting the dosing devices is described in the manual for the 730
Sample Changer or 774 Oven Sample Processor. If no dosing device is
connected then the tab will remain empty.
7.8.6 Properties - RS-232
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ RS-232
COM Port
Selection of the serial interface on the PC to which the device is connected.
Selection COM1 | COM2 | … | COMn
Default value COMn
COMn
First free COM port.
Baud rate
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Selection 1200 | 2400 | 4800 | 9600
Default value 9600
[Connect]
Establishes a connection to the RS-232 device.
[Disconnect]
Disconnects the connection to the RS-232 device.
Note
These parameters are only editable for devices with status not ok (power
supply and/or RS connection interrupted).
7.8.7 Properties - GLP
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ 'Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in the
dialog window Select date (see Chapter 2.5.1, page 79).