Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 375)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 359
Label
Freely definable axis label for the x axis. With auto the designation from the
field Size will be used.
Selection 50 characters | auto
Default value auto
Scaling
Start value
Initial value for scaling the x axis.
Only editable when autoscaling is disabled.
Range
-1.00E+12 ... +1.00E+12
Default value -1.00E+12
End value
End value for scaling the x axis.
Only editable when autoscaling is disabled.
Range
-1.00E+12 ... +1.00E+12
Default value +1.00E+12
4.8.4.3 Curve properties - y1 axis
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS
Default value DET
Note
When the dialog window is opened, those Command type will be selec-
ted as standard which applies for the curve shown in the curve window.