Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1188)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1172 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Identifi-
cation Description
.[VAL] Value of the command variables (optional, i.e. Command
name.Port name' = Command name.Port
name.VAL'). The value returned corresponds to the status
of the IO port after completion of the command
5.6.11.4.2 ANALOG OUT - General
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ General
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type.
Selection IO Controller
Default value IO Controller
5.6.11.4.3 ANALOG OUT - Analog outputs
Tab: Method ▶ ANALOG OUT ▶ Analog outputs
Command name
Name of the command.
Input 25 characters
Table
An analog output is parameterized in every line of the Analog outputs
table. The calculated or fix value is written directly to the selected analog
output in the run.
One port can not be used more than once within a block.