Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 380)

4.8 Curves subwindow ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
364 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Size
Selection of the quantity to be shown on the y2 axis.
For DET commands
Selection
Volume [mL] | Measured value | ERC | Time [s] |
Temperature [°C] | Calculated 1...3 | External
1...3 | off
Default value off
For MET commands
Selection
Volume [mL] | Measured value | dMW | Time
[s] | Temperature [°C] | Calculated 1...3 | Exter-
nal 1...3 | off
Default value off
For SET, STAT, DOS and KFT commands
Selection
Time [s] | Measured value | Volume [mL] | dV/dt
[µL/min] | Temperature [°C] | Calculated 1...3 |
External 1...3 | off
Default value off
For KFC commands
Selection
Time [s] | Measured value | Charge [mAs] |
Amount [µg] | Drift [µg/min] | Ugen | Igen [mA]
| Calculated 1...3 | External 1...3 | off
Default value off
For BRC commands
Selection
Time [s] | Measured value | Amount [mAs] |
Water [µg] | Drift [µg/min] | Ugen | Igen [mA] |
Calculated 1...3 | External 1...3 | off
Default value off
For MEAS commands
Selection
Time [s] | Measured value | dMW/dt | Tempera-
ture [°C] | Calculated 1...3 | External 1...3 | off
Default value off