Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1166)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1150 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Note
Text is selected as type in the default settings for the sample identifica-
tions ID1 … ID16. If you wish to enter numbers for these method
variables for use in later calculations, then these variables must be
switched in the dialog window Method variable - Sample position to
the type number. START
▶ Properties... ▶ Method varia-
bles ▶ [Properties] ▶ Method variables - Sample position
Sample size
on | off (Default value: off)
If this option is switched on, then the sample size will be queried.
Sample size unit
on | off (Default value: off)
If this option is switched on, then the sample size unit will be queried.
Message
on | off (Default value: off)
If this option is enabled, then the message defined here will appear in the
dialog window Sample data request in which the sample data is queried
during the method run (see Chapter 5.6.10.2.3, page 1151). The text editor
for entering or changing the message is opened with or by double-
clicking into the text field (see Chapter 2.5.2, page 79).
Input Text (unlimited)
Note
In the event the option Comments on modification of sample data
(live) is enabled in the Security settings, the dialog window Modifi-
cation comment sample data will be displayed after the sample data
is entered, where a Comment and a Reason for the modification must
be entered.