Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1464)

7.19 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1448 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Note
With the aid of the following parameters the physical values that are
adjacent to the analog input can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Measured value to be used when the Low level (0%) is adjacent as input
value.
Range -214783648 ... 214783647
Default value 0
100% Mapping
Measured value to be used when the High level (100%) is adjacent as
input value.
Range -214783648 ... 214783647
Default value 100
Unit
Unit of the measured value to be used.
Input 50 characters
Default value %
7.19.7 Properties - Analog outputs
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Analog outputs
On the registration card Analog outputs all outputs detected are auto-
matically listed in a table. For each analog output the settings can be
modified.
Port
Display of the internal description of the port.
Port description
Display of the port description.
Type
Display of the port type.
Low level (0%)
Display of the lowest analog output value with unit.