Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 969)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 953
Identification Description
.TC.C3 Coefficient c3 of the Chebyshev polynomial of the sol-
ution used
.TC.C4 Coefficient c4 of the Chebyshev polynomial of the sol-
ution used
.TC.MAX Maximum temperature coefficient in %/°C (
.TC.MIN Minimum temperature coefficient in %/°C (
.TC.TSTART Start temperature in °C
.TC.TSTOP Stop temperature in °C
5.6.4.10.2 MEAS TC Cond - General/Hardware
Tab: Method ▶ MEAS TC Cond ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type.
Selection 712 Conductometer | 856 Conductivity Module
Default value 856 Conductivity Module
Sensor
Sensor
Selection of a sensor of the Conductivity sensor type from the sensors
configured in the sensor table.
Selection Sensor name | Conductivity sensor
Default value Conductivity sensor