Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1444)

7.17 Balances ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1428 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
7.17 Balances
7.17.1 Balance - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device
type' - 'Device name'
The parameters for a balance are set on the following tabs:
￭ General
General device information such as device name, device type, serial num-
ber, etc.
￭ RS-232
Selection of the serial interface the device is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.17.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
General properties of the device are displayed on the General tab.
Device name
Designation of the device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.1.6, page 1331).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.