Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1375)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1359
Start-up
Shows the date on which the device was automatically added to the device
table.
Data storage under legal control
Indicates whether the balance has its own calibratable data memory.
Only visible and editable with Sartorius balances.
Selection
on | off
Default value off
Remarks
Remarks about the device.
Input 1000 characters
Default value empty
7.7.3 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see Chap-
ter 5.6.6.5.1, page 1082) (prepare) is to be shown for the dosing device
connected to the MSB.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dosing
unit the request to prepare the dosing device will appear.
Time interval
on | off (Default value: off)
If this option is switched on then the request to prepare the dosing device
will appear after the time interval defined here.