Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1149)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1133
Titrando, 856, 867, 814, 815, 855, 864, 874
Selection
1 | 2 | 3 | 4
Default value 1
Scan lines
Input signal
Input of the binary pattern for the expected input signal or selecting a pre-
defined signal pattern.
It is possible to enter the following characters:
0 = line inactive
1 = line active
* = any line status
Selection Bit-pattern with 8 characters (0, 1, *) | ********
| Signal pattern
Default value ********
The bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example:
*******1 expects an active input line 0 (1 = set). For example, this line is set
by a Titrino after a titration has been completed and the Titrino can accept
a start signal again.
Note
Input lines that are of no interest or for which no defined condition can
be predicted should also be masked with an asterisk *.
Max. waiting time
on | off (Default value: off)
If this option is activated, then a maximum waiting time can be entered for
the input signal.
Range 0 ... 9999.9
Default value 10
Selection min | s
Default value s