Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 430)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
414 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Parameters
The parameters for the command START are configured on the following
3 tabs:
￭ General
General settings for the method run.
￭ Application note
Writing an application note which is displayed when starting a determi-
nation.
￭ Method variables
Configuring method and sample variables which are to be available for
the method.
Command variables
No command variables are generated in the method run by the START
command.
Method variables
The following method variables are defined in the START command and
can be used in formulas under the designation 'MV.Variable name.Var-
iable designation':
Identification Description
.VAL Result value (optional, i.e. 'MV.Factor'
=MV.Factor.VAL') (Text, Number or
Date/Time)
.OVF Exceeding limits for method variable
(Number: 1 = limit exceeded, 0 = limit
not exceeded)
In the following lines you will find the method variables (sample data)
present in the default settings which appear in the Run subwindow and
which can be edited and deleted in the START command of the corre-
sponding method.
Sample size.VAL Value of 'Sample size' (Number)
Sample size.OVF Exceeding limit for 'sample size' (Num-
ber)
Unit.VAL Value of 'Unit'. (Text)
Unit.OVF Exceeding limit for 'unit' (Number)