Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1315)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1299
Range -2.147E+9 ... 2.147E+9
Default value 7.500
Intervention limits for pH(0) (only for pH electrodes)
on | off (Default value: off)
If this option is switched on, then the values for pH(0) will be shown in
red if the limits are exceeded.
Lower limit
Lower intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 6.000
Upper limit
Upper intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 8.000
Warning limits for E(0) (only for ISE electrodes)
on | off (Default value: off)
If this option is switched on, then the values for E(0) will be shown in
orange if the limits are exceeded.
Lower limit
Lower warning limit for E(0).
Range -2.147E+9 ... 2.147E+9 mV
Default value -15 mV
Upper limit
Upper warning limit for E(0).
Range -2.147E+9 ... 2.147E+9 mV
Default value 15 mV
Intervention limits for E(0) (only for ISE electrodes)
on | off (Default value: off)
If this option is switched on, then the values for E(0) will be shown in
red if the limits are exceeded.
Lower limit
Lower intervention limit for E(0).