Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 190)

3.8 Subwindow Live display ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
174 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
MEAS
Selection
off | Measured value | time | Temperature |
dMW/dt | Calculated 1…3 | External 1…3
Default value off
MEAS T/Flow
Selection
off | Measured value | time | Flow | Calculated
1…3 | External 1…3
Default value off
MEAS TC Cond
Selection
off | Measured value | time | Calculated 1…3 |
External 1…3
Default value off
MEAS Opt
Selection
off | Measured value | time | Intensity | Trans-
mission | Saturated pixels
Default value off
DOS
Selection
off | Measured value | Volume | Temperature |
time | dV/dt | Calculated 1…3 | External 1…3
Default value off
Color
Selection of the curve color for the quantity to be shown on the y2 axis.
Selection Color selection | magenta
Default value magenta
Display measuring points
on | off (Default value: off)
If this option is enabled, then in addition to the curve the single measured
values are shown as crosses.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols again.