Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1271)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1255
Non-intelligent exchange units (EU) and dosing units (DU)
Non-intelligent exchange and dosing units must be added manually to the
solution table.
6.6.2 Solution table
6.6.2.1 Solution table
Subwindow:Configuration ▶ Titrants/Solutions
Contents
In the solution table the following information about automatically recog-
nized or manually added solutions is shown as standard:
Solution name
Name of the solution.
Concentration
Concentration (value and unit) of the solution.
Cylinder volume
Cylinder volume of the exchange or dosing unit in mL.
Type
Type of exchange unit or dosing unit.
Dosing device
Device name and dosing connection of the device to which the exchange
or dosing unit is fitted (only for intelligent exchange/dosing units).
Titer
Titer (value and unit) of the solution.
Date titer det.
Date on which the last titer determination was carried out.
Next titer determination
Date on which the next titer determination is to be carried out. If titer mon-
itoring is switched on and the set date is before the current date (i.e. the
titer determination has not yet been carried out) then the date will be shown
in red.
Expiry date
Expiry date of the solution. If solution monitoring is switched on and the set
date is before the current date (i.e. the expiry date has elapsed), then the
date will be shown in red.