Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1311)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1295
Warning limits for slope (only for pH and ISE electrodes)
on | off (Default value: off)
If this option is switched on, then the values for the slope will be shown
in orange if the limits are exceeded.
Lower limit
Lower warning limit for the slope.
for pH electrode
Range
-2.147E+9 ... 2.147E+9 %
Default value 97.5 %
for ISE (+1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 57.2 mV
for ISE (-1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -61.2 mV
for ISE (+2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 27.7 mV
for ISE (-2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -31.7 mV
for ISE (+3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 17.7 mV
for ISE (-3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -21.7 mV
for ISE (+4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 12.8 mV
for ISE (-4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -16.8 mV