Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 339)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 323
values. Listed below are the individual measured values and the results for
Slope, E(0), c(blank) and Variance. Calibration curve for CAL LOOP Conc
Standard addition curve for STDADD
In the dialog window Calibration curve a tab marked with the command
name showing the standard addition curve and evaluation data will be dis-
played for each STDADD command. The command type is shown above
the calibration curve. The curve display shows the measured values and the
curve calculated from these measured values. Listed below are the individual
measured values and the results for Determination, Show calibration
curve..., E(0), Determination, Show calibration curve... and Var-
iance.
Note
Calibration curves cannot be printed out directly from the dialog window
Calibration curve. Instead you should use a report with a report tem-
plate which contains the fixed report (see Chapter 4.4.1.4.3.7, page
226).
4.5.2.16 Determinations - Control chart
Dialog window: Database ▶ Determinations ▶ Control chart… ▶ Control chart
With the menu item Determinations, Control chart... or the symbol
the dialog window Control chart - 'Template name' opens in which a
control chart is shown for the selected determinations containing statistical
evaluation (mean value, number of determinations, absolute and relative
standard deviation) according to the loaded template.
Template
Selection Standard | 'Template name'
Default value Standard
Standard
Selection of the saved templates for control charts (see Chapter
4.4.2.2.1, page 235). When the dialog window is opened, the last tem-
plate to have been loaded will be shown. If a new template is selected
then the display will be updated automatically.
[Templates]
Open dialog window Templates for control charts (see Chapter 4.4.2,
page 234).
Graphics presentation
Shows the measured values together with warning and intervantion limits
and statistical values according to the settings on the selected control chart.