Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 338)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
322 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
4.5.2.14 Determinations - Displaying history
Menu item: Database ▶ Determinations ▶ Show history
Switch history view on/off
With the menu item Determinations
▶ Display history... or the symbol
only the currently focused determination in the determination table as
well as all the previous versions of this determination will be shown.
If the history view with the menu item Determinations ▶ Show history
or the symbol is disabled again, then the original selection of determi-
nations in the determination table will appear again.
Menu item:Database
▶ Determinations ▶ Make current
Make old version current
With the menu item Determinations ▶ Make current or the symbol
the determination version selected in the determination table will again be
made the current determination version. This creates a new determination
whose version number is increased by +1 compared with the last version to
have been saved.
4.5.2.15 Determinations - Show calibration curve
Dialog window: Database ▶ Determinations ▶ Show calibration curve... ▶ Calibration
curve
With the menu item Determinations, Show calibration curve... or the
symbol the calibration or standard addition curve is shown for the cali-
bration selected in the dialog window Calibration curve.
Calibration curve for CAL LOOP pH
In the dialog window Calibration curve a tab marked with the command
name showing the calibration curve and calibration data will be displayed
for each CAL LOOP pH command (see Chapter 5.6.5.4, page 998). The
command type is shown above the calibration curve. The curve display
shows the measured values and the curve calculated from these measured
values. Listed below are the individual measured values and the results for
Slope, E(0) and Variance.
Calibration curve for CAL LOOP Conc
In the dialog window Calibration curve a tab marked with the command
name showing the calibration curve and calibration data will be displayed
for each CAL LOOP Conc command (see Chapter 5.6.5.6, page 1017). The
command type is shown above the calibration curve. The curve display
shows the measured values and the curve calculated from these measured