Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1317)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1301
6.8 Common variables subwindow
6.8.1 Configuration - Common variables
Subwindow: Configuration ▶ Common variables
Common variables subwindow
The subwindow Common variables contains the table with the configured
common variables. It can be shown in a separate window in the program
part Configuration as a part of the Configuration view or (if not present
on the desktop) with View
▶ Quick access. The subwindow can be
enlarged and reduced as required; it can also be maximized.
Using common variables
Common variables are method-embracing variables that are stored per client
and can be used in formulas under the designation 'CV.Name'. They are
either entered manually in the configuration or assigned in the method run
by a CALC command.
Note
If Common Variables are used in a CALC command then they will only
be requested at the start of the determination. This means that it is not
possible to write Common Variables during a determination and then
reuse the altered value in a different formula. For this you should use
Method variables (see Chapter 2.4.3.2, page 27).
6.8.2 Table of common variables
6.8.2.1 Table of common variables
Subwindow: Configuration ▶ Common variables
Contents
The table of common variables shows the following information about the
common variables as standard:
Name
Name of common variable.
Type
Type of common variables (Number, Text or Date/Time).
Value
Value of common variables.