Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1378)

7.8 730 Sample Changer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1362 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Action
The actions can only be edited if monitoring is switched on.
If during monitoring it is found that the validity period has expired then one
of the following actions will be triggered automatically at Start test.
Selection Record message | Display message | Stop deter-
mination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can choose whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the deter-
mination.
Stop determination
The running determination will be automatically terminated. The follow-
ing message must be confirmed with [OK].
7.8 730 Sample Changer
7.8.1 730 Sample Changer - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device
type' - 'Device name'
The parameters for the device 730 Sample Changer are set on the fol-
lowing tabs:
￭ General
General device information such as device name, device type, serial num-
ber, etc.
￭ Towers
Properties of Tower 1 and Tower 2 (if present). This tab is only displayed
if the Sample Changer is connected to the PC via an RS-232 interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Sample
Changer is connected to the PC via an RS-232 interface.
￭ Dosing device
Properties of the connector and the dosing devices connected to. This
tab is only displayed if the Sample Changer is connected to the PC via an
RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.