2 det upol - general/hardware, General/hardware – Metrohm tiamo 2.1 (ProcessLab) User Manual
Page 530
5.6 Commands
■■■■■■■■■■■■■■■■■■■■■■
514
■■■■■■■■
tiamo 2.1 (ProcessLab)
5.6.3.2.5.2
DET Upol - General/Hardware
Tab: Method
▶ DET Upol ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input
25 characters
The general parameters for the control device, the dosing device, the sensor
and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection
'Device name' | not defined
Default value
not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection
Device types | Titrando
Default value
Titrando
Dosing device
Dosing device
Selection of the number of the dosing device (dosing or exchange unit) with
which the solution is to be dosed. All the dosing device connections which
are possible with the selected device type are displayed.
Titrando
Selection
1 | 2 | 3 | 4
Default value
1