Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1521)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1505
Timeout
Time in seconds or minutes within which the action must have run through
completely. If this is not done after the maximum waiting time has expired,
the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR
[Start]
Sets the stepping motor to ACTIVE.
[Stop]
Sets the stepping motor to INACTIVE.
Reference position
On this tab the reference position of the stepping motor can be moved to.
Port description
Display of the port description.
Port
Display of the internal description of the port.
Type
Display of the port type.
Timeout
Time in seconds or minutes within which the action must have run through
completely. If this is not done after the maximum waiting time has expired,
the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.