Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1487)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1471
730, 774, 778, 789
Range
0.01 ... 160.00 mL/min
Titrino
Range
0.01 ... 150.00 mL/min
Filling rate
The buret is filled at this rate after the dosing. The maximum filling rate
depends on the cylinder volume of the exchange unit or dosing unit used.
If the entered filling rate is too high for the selected dosing device, it will
automatically be reduced during dosing to the largest possible value.
Note
For viscous liquids the filling rate should be reduced.
Selection maximum
Default value maximum
Titrando, 814, 815, 855
Range
0.01 ... 166.00 mL/min
730, 774, 778, 789
Range
0.01 ... 160.00 mL/min
Titrino
Range
0.01 ... 150.00 mL/min
Fill automatically
on | off (Default value: on)
This parameter is only visible for devices of the type Titrando, Dosing Inter-
face and USB Sample Processor.
If this option is enabled, the buret is filled automatically after dosing. During
the filling procedure the volume display is reset to 0.0000 mL. If this option
is disabled, the added volume is displayed cumulatively.
[Start]
Start fixed volume dosing for the selected dosing device. The dosed volume
is displayed live.