Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 318)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
302 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
(see Chapter 5.2.5, page 385). The modified method then appears on the
tab Methods with the addition (modified). This modified method is then
applied to the selected determinations with [Recalculate] and can be saved
at any time with [Save as].
4.5.2.6.4.4 Modifications - Statistics
Tab: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications ▶ Statistics
On the tab Statistics the single results for the statistics calculation can sub-
sequently be switched on and off.
Results with statistics
Result name
Selection of the statistically evaluated result by using the result name for
which the single results of all determinations are shown.
Selection Result name
Table of single results
For the result selected above the following data for the individual determi-
nations is shown:
Determination start
Shows the date and time at which the determination was started.
Version
Shows the version number of the determination.
Sample size
Shows the sample size.
Result value
Shows the result value. The statistics data (mean value, standard deviations,
etc.) for the selected determination are listed in the subwindow Result
view (see Chapter 4.5.2.6.5, page 314).
[Determination on/off]
All single results of the selected determination for statistical calculations can
be switched off or on. If the determination is switched off then an asterisk
(*) appears behind all result values in the table and the line is shown as
inactive (gray); if it is switched on again then the asterisks will disappear.
However, updating the statistics data always only takes place with [Recal-
culate].