Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 482)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
466 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
Start measured value
Note
Is displayed only for Titrando and 855.
Start measured value
Once the start measured value is reached, the dosing of the start volume is
stopped and the next start condition is processed or the titration is started.
If the start measured value is achieved by the addition of a start volume,
then titration will start directly.
Range -2000.0 ... 2000.0 mV
Selection off
Default value off
Dosing rate
Speed at which the start volume is added until the start slope is reached.
The maximum dosing rate depends on the cylinder volume of the exchange
unit or dosing unit used.
Range 0.01 ... 166.00 mL/min
Default value 5.00 mL/min
Selection maximum
Start slope
Note
Is displayed only for Titrando and 855.
Start slope
When the start slope is reached the dosing of the start volume is stopped
and the titration is started. If the start slope is achieved by the dosing of a
start volume then the titration starts directly.
Range 0 ... 999 mV/mL
Selection off
Default value off