Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1294)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1278 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Standard sensors
The sensor table contains the following sensors as standard; these cannot
be deleted:
￭ Conductivity sensor
￭ ISE electrode (ion-selective electrode)
￭ Metal electrode
￭ pH electrode
￭ Temperature sensor
6.7.2 Sensor table
6.7.2.1 Sensor table
Subwindow: Configuration ▶ Sensors
Contents
In the sensor table the following information about the configured sensors
is shown as standard:
Sensor name
Name of the sensor.
Sensor type
Type of the sensor. Intelligent sensors will be marked with IS and shown
automatically in green.
Device
Name of device to which sensor is connected.
Measuring input
Device and measuring input to which the sensor is connected. In the case
of intelligent sensors, the device and the measuring input are displayed with
green lettering.
Set to work
Date on which the sensor was used for the first time.
Expiry date
Expiry date of the sensor. If sensor monitoring is switched on and if the set
date is before the current date (i.e. the working life has elapsed) then the
date will be shown in red.
Slope
Slope of the sensor in % or mV.