Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 159)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 143
￭ Conditioning condition fulfilled
If the conditioning requirement has been fulfilled, then the status will
switch to COND READY. The method is then started automatically
afterwards.
5 - Method start
The following checks and actions are triggered with method start:
￭ Assign determination ID
A unique determination ID is assigned for the determination.
￭ Reserve devices (modules)
The devices and/or their function units used by the device-dependent
commands in the method are reserved for the duration of the determi-
nation, i.e. they can neither be used in other workplaces nor can they be
operated manually.
￭ Increase sample number
The sample number is increased by +1.
￭ Increase statistics counter
If Statistics is switched on, both in the START command and on the
Determination series tab, then the statistics counter will be increased
by +1. If a new method has been loaded or if the statistics counter cor-
responds to the setpoint counter, then the current statistics data is
deleted beforehand and the statistics counter is set to 0.
6 - Main procedure
The following actions can be carried out during processing of the method
loaded:
￭ Process series start track
The series start track is started at the beginning of the first determi-
nation of a series. If [Stop] is pressed during the running of this track,
then the Exit track is started; if an error occurs, then the error track
will be.
￭ Process the main track
The status switches to BUSY after the start of the main track. The main
track commands and those of the other tracks it calls up are processed
in sequence. If tracks which are not free are called up by the main track,
then a waiting period will be observed until these tracks can be started.
￭ Interrupt and continue run
A determination that is running can be interrupted at any time with
[Hold] and resumed with [Cont]. All active tracks are interrupted and
resumed together when this is done.