Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1411)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1395
With the 856 Conductivity Module displayed only.
Selection
Pt 1000 | NTC
Default value Pt 1000
R (25 °C)
Nominal resistance of connected NTC sensor.
Only visible with temperature sensors of the NTC type.
Range
1000 ... 99999 Ohm
Default value 30000 Ohm
B value
Material constant of the NTC resistance referred to measuring the resistance
at 25 °C and 50 °C.
Only visible for temperature sensors of the NTC type.
Range
1000 ... 9999
Default value 4100
7.12.4 Properties - Tower #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower #
On the tab Tower the properties of the tower and of the robotic arm con-
nected to are displayed.
Tower parameters
Max. stroke path
Entry of the lowest permitted lift position. A lift height of 0 mm corresponds
to the "Home position", i.e. the lift is moved right to the top.
Range 0 ... 235 mm
Default value 235 mm
Min. beaker radius
Definition of the minimum radius which the beakers used on the rack must
have. If the lift is moved to the work position the beaker radii defined in
Rack table(see Chapter 6.10.2.1, page 1317) for general Sample posi-
tions(see Chapter 6.10.3.2, page 1320) and Special beakers(see Chapter
6.10.3.4, page 1322) will be compared with the Min. beaker radius. If
this minimum beaker radius is undercut then the run will be stopped and an
error message will appear. With off no check will be made.
Selection 1.0 … 100.0 mm | off
Default value off