Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1150)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1134 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
5.6.9.4 SEND
5.6.9.4.1 SEND - Overview
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command for Sending event messages to commands, tracks or to
tiamo.
Appearance
The command has the following appearance:
Parameters
The parameters for the command SEND are configured in the following
dialog window:
￭ SEND - Properties
Command variables
The following command variables are generated in the method run by the
command SEND and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.9.4.2 SEND - Properties
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command name
Name of the command.
Input 25 characters
All the Event messages listed in the table are sent simultaneously. The table
cannot be edited directly.