Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1503)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1487
Measured quantity
The selectable measured quantities depend on the device whose measuring
input has been selected in the device selection.
Selection pH | U | Ipol | Upol | Temperature | Conc | Cond
Note
Which other parameters are displayed depends on the selected measured
quantity.
Sensor
Select the sensor, the ones of the sensor table are available. Depending on
the measured quantity only specific sensor types can be selected.
Note
If an intelligent sensor is connected to the measuring input it is displayed.
Measurement temperature
Temperature, which can be entered manually. If a temperature sensor is
connected, the temperature is measured continuously and the value entered
will be ignored. The value is used for the temperature correction of the
measurement.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value 25.0 °C
I(pol)
The polarization voltage is the voltage applied to the polarizable electrode
during a amperometric measurement.
Titrando, 855
Range
-125.0 ... 125.0 µA (Increment: 0.5)
Default value 5.0 µA