Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 401)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 385
Command without comment Command with comment
5.2.5 Checking method
Menu item: Method ▶ File ▶ Method check
With the symbol or menu item File ▶ Method check a method check
for the method in focus is triggered. The following points are checked:
￭ Are the tracks defined in CALL commands available?
￭ Are the targets of loop commands defined?
￭ Are the variables defined in calculation formulas available?
￭ Does a track contain more than one command with conditioning acti-
vated?
￭ Does a special track (Series start track, Series end track, Exit track and
Error track) contain a command with conditioning activated?
A message is displayed for each error found. The method check has to be
started again afterwards. When the method check has been completed suc-
cessfully, it is confirmed with a message.
5.2.6 Saving method
Menu item: Method ▶ File ▶ Save / Save as…
With the symbol or the menu item File ▶ Save an existing focused
method is saved again under its name without the window Save method
being opened.
When saving a newly created method with File ▶ Save or when saving an
existing method with File ▶ Save as... the dialog window Save method
is opened, in which the method group can be selected and a method name
can be entered or selected.
Method group
Method group
Selection of the method group where the method is to be stored (see Chap-
ter 5.4.1, page 400).
Selection Method groups | Main group
Default value Main group
Method table
The method table contains information about all methods of the selected
method group. The table cannot be edited. With a click on the column title
(columns Name, Saved, User, Full name, Version, Signed, Method