Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 528)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
512 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the com-
mand) in mL
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.FP{x}.ERC ERC for the fixed endpoint × (1…9)
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1…9) in mL
.GP.VOL Volume for the Gran endpoint in mL
.GP.MEA Measured value for the Gran endpoint in the unit of the
measured value
.GP.TEM Temperature for the Gran endpoint in °C
.GP.TIM Time in s until the Gran endpoint is reached
.HP{x}.MEA Measured value for the HNP × (1…9) in mV (HNP = half
neutralization potential)
.HP{x}.TEM Temperature for the HNP × (1…9) in °C
.HP{x}.TIM Time in s until the HNP × (1…9) is reached
.HP{x}.VOL Volume for the HNP × (1…9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.ERC ERC for the last measuring point in the measuring point
list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point in the unit
of the measured value of the measuring point list