Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1299)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1283
Order number
Order number of the sensor (read-only for intelligent sensors).
Input 24 characters
Default value 'empty'
Sensor serial number
Serial number of the sensor (read-only for intelligent sensors).
Input 10 characters
Default value 'empty'
Device
For non-intelligent sensors it is possible to select the device to which the
sensor is connected. All the devices in the device table which have a meas-
uring input are shown in the selection list. The connection of a sensor to a
particular device is not checked during the run. In the case of intelligent
sensors, the device to which the sensor is connected is shown here auto-
matically.
Selection Selecting device | 'empty'
Default value 'empty'
Measuring input
For non-intelligent sensors it is possible to select here the measuring input
to which the sensor is connected. The connection of a sensor to a particular
measuring input is not checked during the run. This parameter only appears
if a Device has been chosen. For intelligent sensors the measuring input to
which the sensor is connected is shown here automatically.
Selection 1 | 2
Default value 1
Comment
It is possible to enter remarks about the sensor.
Input 24 characters
Default value 'empty'
Set to work
The current date is automatically entered here for a newly added sensor.
When editing an existing sensor, the date can be selected by pressing in
the dialog window Select date (see Chapter 2.5.1, page 79).