Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 836)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
820 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration. The
maximum filling rate depends on the cylinder volume of the exchange unit
or dosing device used.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.8.6.7 STAT pH - Monitoring
Tab: Method ▶ STAT pH ▶ Properties... ▶ Monitoring
Command name
Name of the command.
Input 25 characters
The following monitoring processes can be switched on and defined on this
tab:
Monitoring Measured value
Monitoring Measured value
on | off (Default value: off)
If this option is switched on then the measured value will be monitored and
any exceeded limits will be entered in the measuring point list.
Lower limit pH
Lower limit of the measured value. When the measured value falls below
this value, the event Measured value lower limit exceeded is triggered.
Titrando, 855
Range
-20,000 ... 20,000
Default value -20,000
Titrino
Range
-20.00 ... 20.00
Default value -20.00